Page: OptiClose Secure Mesh

Instructions for Use

Before using product, read the complete Instructions for Use (see the “Docs” section under each product SKU).

Remove both sections of the white release liner from the mesh, peeling from the center towards the outer edge

Hold the mesh by the clear release liner, refraining from touching the mesh
With the mesh facing the wound, position so the incision is central to the mesh (without making contact), ensuring that at least 1 cm of mesh extends from each end of the incision
Press gently to ensure intimate contact of the mesh to one side of the incision
Gently pull the mesh perpendicularly over the incision while adjusting with fingers or forceps to achieve skin edge approximation and affix the remainder of the mesh to the other side of the incision
Pat the clear release liner down so that the mesh has fully adhered to the skin
Remove the clear release liner by maintaining pressure on the clear release liner whilst pulling the release tab from the mesh in the opposing direction
Tear the clear release liner and remove in a circular direction
For incisions longer than 20 cm, repeat steps 5-11; for the continuation of skin edge approximation, overlap the end of the existing mesh by approximately 1 cm
Activate the liquid adhesive applicator by holding the applicator with finger and thumb by the wings with the tip pointed upwards and away from the patient; squeeze the applicator wings to apply sufficient pressure to fully crush the inner glass ampoule
Invert the applicator and firmly squeeze the wings to express the liquid adhesive and IMMEDIATELY apply to the mesh
Spread the liquid adhesive smoothly and evenly over the entire length of the mesh using the foam tip, making sure that the entire mesh is covered; the liquid adhesive should also be applied slightly over the edge of the mesh, covering a small margin of surrounding skin

Patient Wound Care Instructions

      • Keep the wound dry. Do not soak or scrub the wound area. If directed by a healthcare provider, the wound may be wet briefly in a shower. To dry, gently pat with a soft towel or cloth. If bandaged, keep the bandage dry or replace if it becomes wet.

      • Avoid topical medications. Do not apply liquid or ointment medications, lotions, creams, petroleum jelly, mineral oils or any other product to the wound while OptiClose Secure adhesive film is in place.

      • Do not rub, scratch or pick at the wound.

      • Report any discomfort or other concerns to a healthcare provider.

      • Do not engage in strenuous physical activity that may cause tension on the incision or cause perspiration to wet OptiClose Secure.

      • OptiClose Secure should remain in place until the incision has healed (typically 7-14 days).